Lencore n.Form: MPI-6 Manual do Utilizador Página 1

MPI-6 User ManualVersion 1.1

section 22.5 | mic paging 81. Connect a MIC to Lencore’s MIC pre-amp.2. Connect the audio output of the MIC pre-amp to one of the six audio inputs of

section 22.5 | RAMP paging9Use with a RAMP:Note: DIP switch 5 on the RAMP must be down.Relay outputs 1-8 can be used to trigger RAMP messages to repla

section 22.6 | relay outputs10Paging Priorities:MIC all-call over phone.MIC all-call over MIC zone.Phone all-call over MIC zone.Last MIC zone triggere

section 22.7 | audio inputsAudio input adjustment (figure 6) – There are six audio input adjustments – one for each audio input. Using a flat-blade s

section 22.8 | audio input adjustment12Other:Service button (figure 2)-Pressing the Service button plays a short audio clip over the audio source 6 li

section 22.8 | audio input adjustment13Internal speaker source select (figure 1)-The rotary selector switch can select the audio source to play over t

section 22.9 | overall I/O14figure 7 - overall I/O

The information contained herein is proprietary to Lencore Acoustics Corp. and copyright protected. No part of this manual can be copied, used or dis

MPI-6section 0 page 1section 1 page 2 IMPORTANT SAFETY INSTRUCTIONS & PRECAUTIONS INTRODUCTION - ABOUT MPI-61.1 basic information on MPI-6page

Follow all instructions.Do not use this equipment near water.Clean only with dry cloth.Do not block any ventilation openings. Install in accordance w

introductionMPI-62The MPI-6 is Lencore’s music and page interface to be used for Emerald and iNET systems. The MPI-6 includes an analog

section 11.1 | components 3• Power LED.• Status LED.• Input level LEDs for music and paging (RCA inputs only – not phone).• Neuron status LEDs.• Rela

section 22.1 | inputs and outputs 4• Power input.• POTS line input (RJ11).• Ground 2-pos terminal block (screw terminals).• iLON input 2-pos terminal

section 22.2| LEDs and switches 5Power – solid when board is poweredStatus – blinks every 8 seconds and solid when paging. Solid when an IR remote bu

section 22.3 | operation 6figure 1- overall MPI-6Plug the power adapter into the MPI. The Power LED will be on and solid while the Status LED will bl

section 22.4| phone paging 71. Plug the analog phone line (RJ11) into the MPI Phone input.2. Dial the extension of the phone line. The Status LED wil